Factory Default; Figure 71: Factory Default Screen; Figure 72: Partial Restore Screen - Quasar CM-4251 Series User And Installation Manual

7.3.17 Factory Default

The Factory default page is shown below. Follow the instructions to reset the camera to factory
default settings if needed.
Full Restore
Click Full Restore to restore the factory default settings. The system restarts in 30 seconds.
Note:
The IP address and all other settings will be restored to factory default settings.
Partial Restore
Click Partial Restore to restore the factory default settings, but save the network settings. The
system restarts in 30 seconds.

Figure 71: Factory Default Screen

Figure 72: Partial Restore Screen

Configuration and Operation
73