Quasar CM-4251 Series User And Installation Manual page 73

Quasar CM-4251 Series User and Installation Guide
Triggered Action
The Administrator can specify various alarm actions to be taken when an alarm is triggered. The
options are listed below.

Enable alarm output – Check this box and select the predefined type of alarm output (low or
high) to enable alarm relay when tampering is detected.

Record stream to sd card -– Select this box in order to save the alarm-triggered recording
into a microSD/SDHC card. Enter the number of seconds for the pre-trigger buffer. Select the
first radial button to upload for a specified length of time and enter the number of seconds.
Alternatively, select the second radial button to upload during the active trigger. See Figure
53: Application – Record Stream to SD Card.
Note:
Make sure that local recording (with a microSD/SDHC card) is activated so that
this function can be implemented. See

Send message by FTP/E-Mail – Select whether to send an alarm message by FTP and/or
e-mail when a network failure is detected.
Save
Click Save to save the network failure detection settings.
62
Recording for further details.