Mounting The Cm-4251-11-I Outdoor Camera; Figure 12: Input/Output Connections And Reset Button; Figure 13: Base Plate Used As A Template To Mark Drilling Locations - Quasar CM-4251 Series User And Installation Manual

7. If needed, connect the other end of the Cat 5 cable to the network and turn on the power
from the power supply.
Note:
Do not reassemble the camera's inner cover and Mini-Dome cover until after
hardware configurations and lens adjustments are made.

5.6.3 Mounting the CM-4251-11-I Outdoor Camera

1. Do one of the following:

For drilled wall or ceiling mounting:
a) Use a pointed pencil and the base plate as a template to mark the mounting surface
through the plate holes where the four screw holes will need to be drilled.
Caution:
Before marking and drilling the holes, ensure that the base plate alignment is oriented
correctly so that the required camera field of view can be achieved when the system is
assembled.

Figure 13: Base Plate Used as a Template to Mark Drilling Locations

Figure 12: Input/Output Connections and Reset Button

Installation
15