Quasar CM-4251 Series User And Installation Manual page 71

Quasar CM-4251 Series User and Installation Guide

Upload Image by FTP – Select this box in order to upload an image to a designated FTP site
when motion is detected according to various parameters, as seen in Figure 54: Application
– Upload Image by FTP. Specify the FTP address to use from the drop-down menu. Select
the number of frames for the pre-trigger and post-trigger buffers from the drop-down menu
of 1-20 frames.
Check the box for Continue image upload if you wish to use this option. To specify the length
of time for the upload, click on this radial button and enter the number of seconds. To
upload during the active trigger, click on this radial button. Finally, select the number of
frames per second from the drop-down menu next to Image frequency.

Upload Image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters, as seen in Figure 55: Application – Upload Image by E-Mail. When
motion is detected, event images are sent to one of two designated e-mail addresses. Select
the number of frames for the pre-trigger and post-trigger buffers from the drop-down menu
of 1-20 frames.
Check the box for Continue image upload to use this option. To specify the length of time for
the upload, click on this radial button and enter the number of seconds. To upload during
the active trigger, click on this radial button. Finally, select the number of frames per second
from the drop-down menu next to Image frequency.
Note:
Make sure that SMTP or FTP configuration has been completed. See
for further details.

Send HTTP notification – Check this box to send a notification by HTTP. Select the destination
HTTP address from the drop-down menu and specify the parameters for event notifications
by motion detection triggered. When an alarm is triggered, the notification will be sent to
one of two specified HTTP servers. See Figure 56: Application – Send HTTP Notification.
Note:
Make sure that local recording (with a microSD/SDHC card) is activated so that this
function can be implemented. See
File Name
The uploaded image's filename format is set in this section. Select one that meets your
requirements.
Save
Click Save to save the motion detection settings.
60
Recording for further details.
Mail and FTP