Factory Default - Quasar CM-4321 User And Installation Manual

CM-4321 User and Installation Guide

7.3.17 Factory Default

The Factory default page is shown below. Follow the instructions to reset the camera to factory
default settings if needed.
Full Restore
Click Full Restore to restore the factory default settings. The system restarts in 30 seconds.
Note:
The IP address and all other settings will be restored to factory default settings.
Partial Restore
Click Partial Restore to restore the factory default settings, but save the network settings. The system
restarts in 30 seconds.
Reboot
Clicking Reboot restarts the system without changing current settings.
54
Figure 59: Factory Default Screen