Quasar CM-4251 Series User And Installation Manual page 52

Enable IP Filter
1. Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4)
are allowed/denied access to the camera.
2. Select Allow or Deny from the drop-down menu.
3. Click Apply to determine the IP Filter behavior.
Add/Delete IP Address
1. Enter the IP address in the Filtered IP Addresses text box.
2. Click Add to add a new filtered address. The Filtered IP Addresses box shows the currently
configured IP addresses. Up to 256 IP address entries may be specified.
3. To remove an IP address from the list, select the IP address and then click Delete.
Configuration and Operation
41