Special Tools - Yamaha XT660R S Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
Slide hammer bolt
90890-01083
Weight
90890-01084
90890-01135
Attachment
90890-01243
Compressor
90890-04019
90890-01268
Pot
90890-01274
Bolt
90890-01275
90890-01304
90890-01325
Tool name/Function
Slide hammer bolt
Weight
These tools are used to remove or install
the rocker arm shafts.
Crankcase separating tool
This tool is used to remove the crank-
shaft.
Valve spring compressor attachment
Valve spring compressor
These tools are used to remove or install
the valve assemblies.
Ring nut wrench
This tool is used to loosen or tighten the
steering ring nuts.
Crankshaft installer pot
Crankshaft installer bolt
These tools are used to install the crank-
shaft.
Piston pin puller set
This tool is used to remove the piston pin.
Radiator cap tester
This tool is used to check the cooling sys-
tem.
http://manuals.magnamaniac.com
SPECIAL TOOLS
1 - 7
GEN
INFO
Illustration