Lubricating The Drive Chain; Checking And Adjusting The Steering Head - Yamaha XT660R S Service Manual

CHECKING AND ADJUSTING THE STEERING HEAD

LUBRICATING THE DRIVE CHAIN/

http://manuals.magnamaniac.com
3 - 44
EAS00142
LUBRICATING THE DRIVE CHAIN
The drive chain consists of many interacting
parts. If the drive chain is not maintained prop-
erly, it will wear out quickly. Therefore, the
drive chain should be serviced, especially
when the motorcycle is used in dusty areas.
This motorcycle has a drive chain with small
rubber O-rings between each side plate.
Steam cleaning, high-pressure washing, cer-
tain solvents, and the use of a coarse brush
can damage these O-rings. Therefore, use
only kerosene to clean the drive chain. Wipe
the drive chain dry and thoroughly lubricate it
with engine oil or chain lubricant that is suit-
able for O-ring chains. Do not use any other
lubricants on the drive chain since they may
contain solvents that could damage the O-
rings.
Recommended lubricant
Engine oil or chain lubricant
suitable for O-ring chains
EAS00146
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the motorcycle on a level surface.
WARNING
_
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
_
Place the motorcycle on a suitable stand so
that the front wheel is elevated.
2. Check:
• steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness → Adjust the steering
head.
CHK
ADJ