Yamaha XT660R S Service Manual page 170

È
É
È
É
1
2
FRONT AND REAR BRAKES
1
2
http://manuals.magnamaniac.com
4 - 23
2. Measure:
• brake pad wear limit a
Out of specification → Replace the brake
pads as a set.
Brake pad wear limit
1.0 mm (0.04 in)
È XT660R
É XT660X
3. Check:
• brake pad pin(s)
Damage/wear → Replace.
4. Install:
• brake pad springs
• brake pads
NOTE:
_
Always replace the brake pads and brake pad
springs as a set.
M MMM M MMM M M MMM M
a. Connect a clear plastic hose 1 tightly to the
bleed screw 2. Put the other end of the
hose into an open container.
È XT660R
É XT660X
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
c. Tighten the bleed screw.
Bleed screw
14 Nm (1.4 m · kg, 1.0 ft · lb)
CHAS
M MMM M M MMM M M MMM M MMM