Checking The Front Fork - Yamaha XT660R S Service Manual

CHECKING AND ADJUSTING THE STEERING HEAD/
1
2

CHECKING THE FRONT FORK

http://manuals.magnamaniac.com
3 - 46
d. Check the steering head for looseness or
binding by turning the front fork all the way
in both directions. If any binding is felt,
remove the lower bracket and check the
upper and lower bearings.
Refer to "STEERING HEAD" in chapter 4.
e. Install the rubber washer 2.
f. Install the upper ring nut 3.
g. Finger tighten the upper ring nut 3, and
then align the slots of both ring nuts. If nec-
essary, hold the lower ring nut and tighten
the upper ring nut until their slots are
aligned.
h. Install the lock washer 1.
NOTE:
_
Make sure the lock washer tabs a sit correctly
in the ring nut slots b.
L LLL L LLL L L LLL L
7. Install:
• upper bracket
• washer
• steering stem
130 Nm (13.0 m · kg, 94 ft · lb)
8. Tighten:
• upper bracket pinch bolts
23 Nm (2.3 m · kg, 17 ft · lb)
9. Install:
• handlebar
• upper handlebar holders
23 Nm (2.3 m · kg, 17 ft · lb)
• handlebar holder caps
• handlebar protector (XT660X)
• handlebar protector cover (XT660X)
Refer to "HANDLEBAR" in chapter 4.
EAS00149
CHECKING THE FRONT FORK
1. Stand the motorcycle on a level surface.
WARNING
_
Securely support the motorcycle so that
there is no danger of it falling over.
2. Check:
• inner tubes 1
Damage/scratches → Replace.
• oil seals 2
Oil leakage → Replace.
CHK
ADJ
L LLL L L LLL L L LLL L LLL