Figure 2-23 Inferface Of System Advanced Configuraiton - New Rock Technologies OM10 User Manual

Figure 2-23 Inferface of system advanced configuraiton

Table 2-21 Parameters of system advanced configuration
Title
Session border
proxy
Server
Signaling port
DTMF
DTMF method
2833 payload type
Sending DTMF
on-time
Shanghai New Rock Technologies Inc.
Explanation
Set the IP address and port number of session border proxy server. The
character of ":" must be used between IP address and port number.
Server address could be set into IP address or domain name. When
domain name is used, "DNS service" must be activated as shown in the
page of "Configure network parameter", and "DNS server" must be
configured.
Examples: "201.30.170.38:5060" and "softswitch.com:5060".
Signaling port value of the OM，the default value is 4660. Signaling port
number could be set at will, but can not conflict with other ports of
equipment.
Transmission modes of DTMF signal supported by the OMs include
Audio, RFC 2833 and SIP INFO. The default value is Audio.
Audio: DTMF signal is transmitted to the platform with sessions;
SIP INFO: Separate DTMF signal from sessions and transmit it to the
platform in the form of SIP INFO messages;
RFC 2833: Separate DTMF signal from sessions and transmit it to the
platform through RTP data package in the format of RFC2833.
Used with "RFC 2833" in the DTMF transmission modes. The default
value of 2833 payload type is 100. The effective range available: 96 ~
127. This parameter should match the setting of far-end device (e.g.
platform).
This parameter sets the on time (in ms) of DTMF signal sent from FXO
port. The default value is 100 ms. Generally, the duration time should be
set in the range of 80 ~ 150 ms.
Page50/75