Figure 2-4 Dialing Rule Configuration Interface - New Rock Technologies OM10 User Manual

Figure 2-4 Dialing rule configuration interface

Table 2-4 Configuration parameters of dialing plan
Name
Outbound
Prefix
Outbound
Selection
Group
Prefix
Shanghai New Rock Technologies Inc.
Description
Used for selecting a trunk for an outgoing call. Value range: 0~9.
The types of trunk for outgoing calls:
FXO: Using analog trunks for outgoing calls with the corresponding
prefix. Example: if the prefix of analog trunk is set to 9, users dial 9 to
select an analog trunk for outbound call. Click
specified analog trunks.
IP: Using SIP trunks for outgoing calls with the corresponding prefix.
Example: if the prefix of IP trunk is set to 6, users dial 6 to select an
SIP trunk for outbound call. Click
trunks.
Route: Selecting the trunks according to the routing table.
Note: If an outbound trunk is not specified, the equipment will select any
available trunk.
Used to define outbound line.
Used for selecting the group when making an incoming call. Optional
value: 0~9.
to select the
to select the specified SIP
Page27/75