Ip Trunk - New Rock Technologies OM10 User Manual

Name
DID
Outbound
Greeting
Recording
Detect CID

2.5.2 IP Trunk

After login, click "Trunking > IP Trunk" tab to open the configuration interface.
Figure 2-13 General configuration interface of IP trunk
Table 2-12 General configuration parameter of IP trunk
Name
ID
Enable
Phone number
Concurrent
Password
Registration
DID
Outbound
Greeting
Shanghai New Rock Technologies Inc.
Description
Set an extension number bound with this analog trunk. Enter the
extension number to enable DID function. When there is an incoming
call on this line, the system will ring the corresponding extension
directly.
Select if Outbound is activated. This line can only be used for incoming
calls when this function is activated.
Set the operator greeting for this analog trunk. The default greeting is
used when the status is off.
Select if Recording is activated. The OM will record calls (including
incoming and outgoing calls) on this analog trunk when this function is
activated.
Select if Caller ID detection is activated.
Description
IP Trunk ID, which is automatically identified by the system.
Enable this IP line.
Assign a phone number for this trunk line. When there is no caller ID
display, the system will use this number as the caller ID. This number is
also used in the Call Detail Record (CDR).
Set the maximum concurrent calls allowed on the trunk. The default is
1.The number must be no bigger than the total number SIP trunks.
Configure an authentication password for the registration account.
Obtain it for the operator or system administrator.
Select if this account is registered with the operator. By default, this is
off.
Set an extension number bound with this analog trunk. Enter the
extension number to enable DID function. When there is an incoming
call on this line, the system will ring the corresponding extension
directly.
Select if Outbound is activated. This line can only be used for incoming
calls when this function is activated.
Set the operator greeting for this analog trunk. The default greeting is
used when the status is off.
Page38/75