Interfaces - Juniper JUNOS OS 10.4 Manual

Junos OS 12.1 MX Series 3D Universal Edge Routers Solutions Guide
Related
Documentation
Example: Configuring Ethernet Frame Delay Measurements with Untagged Interfaces
134
8
9
10
Average two-way delay
Average two-way delay variation: 8 usec
Best case two-way delay
Worst case two-way delay
The collected delay statistics are also saved (up to 100 per session) and displayed as
part of the MEP delay statistics on Router
user@MX-1> show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain md6
MEP identifier: 201, MAC address: 00:90:69:0a:43:94
Remote MEP count: 1
Remote MAC address: 00:90:69:0a:48:57
Delay measurement statistics:
Index One-way delay
1
2
3
4
5
6
7
8
9
10
Average two-way delay
Average two-way delay variation: 8 usec
Best case two-way delay
Worst case two-way delay
Ethernet OAM
Ethernet Frame Delay Measurements on page 119
Configuring MEP Interfaces to Support ETH-DM on page 122
Triggering an ETH-DM Session on page 123
Viewing ETH-DM Statistics on page 124
Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 125
Configuring ETH-DM with Untagged Interfaces on page 134
Ethernet frame delay measurements are supported on untagged interfaces. All commands
are the same as for tagged interfaces. Only the configurations are different. This section
shows the untagged interface configurations for Routers
NOTE: These are not complete router configurations.
92
92
108
: 103 usec
: 92 usec
: 122 usec
.
MX-1
Two-way delay
(usec) (usec)
100
92
92
111
110
119
122
92
92
108
: 103 usec
: 92 usec
: 122 usec
and .
MX-1 MX-2
Copyright © 2012, Juniper Networks, Inc.