Configuring Router Pe2 With A Remote Interface Switch Over Aggregated; Ethernet - Juniper JUNOS OS 10.4 Manual

Junos OS 12.1 MX Series 3D Universal Edge Routers Solutions Guide
Router CE2
Configuration
Configuring Router PE2 with a Remote Interface Switch over Aggregated Ethernet
Router CE1
Configuration
88
}
Configure the dual-tagged Ethernet interface.
[edit]
interfaces {
ge-0/0/0 {
flexible-vlan-tagging;
encapsulation flexible-ethernet-services;
unit 0 {
vlan-tags outer 100 inner 34;
family inet {
address
30.1.1.10/24;
}
}
}
}
You verify your configuration on the MX Series router with the
user@PE2>show connections
CCC and TCC connections [Link Monitoring On]
Legend for status (St)
UN -- uninitialized
NP -- not present
WE -- wrong encapsulation
DS -- disabled
Dn -- down
-> -- only outbound conn is up
<- -- only inbound
Up -- operational
RmtDn -- remote CCC down
Restart -- restarting
Connection/Circuit
trans
rws1
1
ge-0/2/0.0
lsp2-1
lsp1-2
The configuration of the remote interface switch is based on RSVP-signaled MPLS
connections.
Configure Ethernet over ATM on the ATM interface.
[edit]
interfaces {
at-2/0/0 {
encapsulation ethernet-over-atm;
atm-options {
vpi 100;
}
Legend for connection types
if-sw:
rmt-if: remote interface switching
lsp-sw: LSP switching
tx-p2mp-sw: transmit P2MP switching
rx-p2mp-sw: receive P2MP switching
conn is up Legend for circuit types
intf -- interface
tlsp -- transmit LSP
rlsp -- receive LSP
Type
rmt-if
intf Up
tlsp Up
rlsp Up
command:
show connections
interface switching
St Time last up
Up May 13 11:25:40
Copyright © 2012, Juniper Networks, Inc.
# Up