Junos OS 12.1 MX Series 3D Universal Edge Routers Solutions Guide
Related
Documentation
Example: Configuring Ethernet LFM for Aggregated Ethernet
140
pdu-threshold 5;
}
}
}
}
}
Configure LFM on the PE2 router with CCC:
2.
[edit]
interfaces ge-1/0/0 {
encapsulation ethernet-ccc;
unit 0;
}
protocols {
oam {
ethernet {
link-fault-management {
interface ge-1/0/0 {
pdu-interval 1000;
pdu-threshold 5;
}
}
}
}
}
Ethernet OAM
Ethernet OAM Link Fault Management on page 137
Example: Configuring Ethernet LFM Between PE and CE on page 138
Example: Configuring Ethernet LFM for Aggregated Ethernet on page 140
Example: Configuring Ethernet LFM with Loopback Support on page 142
In this example, LFM is configured on an aggregated Ethernet interface (AE0) between
Router 1 and Router 2. When configured on aggregated Ethernet, LFM runs on all the
individual member links. LFM is enabled or disabled on the member links as they are
added or deleted from the aggregation group. The status of individual links is used to
determine the status of the aggregated interface.
The use of LFM with aggregated Ethernet is shown in
Figure 21: Ethernet LFM for Aggregated Ethernet
Figure 21 on page
140.
Copyright © 2012, Juniper Networks, Inc.