Example: Configuring Ethernet Lfm For Ccc; Figure 20: Ethernet Lfm For Ccc - Juniper JUNOS OS 10.4 Manual

Related
Documentation

Example: Configuring Ethernet LFM for CCC

Copyright © 2012, Juniper Networks, Inc.
link-fault-management {
interface ge-1/1/0 {
pdu-interval 1000;
pdu-threshold 5;
}
}
}
}
}
Ethernet OAM
Ethernet OAM Link Fault Management on page 137
Example: Configuring Ethernet LFM for CCC on page 139
Example: Configuring Ethernet LFM for Aggregated Ethernet on page 140
Example: Configuring Ethernet LFM with Loopback Support on page 142
In this example, LFM is configured between two PEs (PE1 and PE2) connected using CCC.
With LFM in place, a link fault will be detected immediately, instead of depending on
routing protocols to find the fault on end-to-end CCC connection. This also helps in
detecting the exact failed link instead of only finding that the end-to-end CCC connectivity
has failed. Also, because LFM runs at the link-layer level, it does not need a IP address
to operate and so can be used where bidirectional fault detection (BFD) cannot.
The links running LFM are shown in

Figure 20: Ethernet LFM for CCC

To configure Ethernet LFM between two PEs connected using CCC:
Configure LFM on the PE1 router with CCC:
1.
[edit]
interfaces ge-1/1/0 {
encapsulation ethernet-ccc;
unit 0;
}
protocols {
oam {
ethernet {
link-fault-management {
interface ge-1/1/0 {
pdu-interval 1000;
Chapter 12: IEEE 802.3ah OAM Link-Fault Management
Figure 20 on page 139
139