Sea-doo SP Shop Manual page 63

Section 03 ENGINE
Sub-Section 05 (TOP END)
1
F01D0VA
1. Thrust washer each side
– Insert piston pin into piston until it comes flush
with inward edge of piston hub.
1
F01D0RA
1. Piston pin flush here
2. Thrust washers
– Place piston over connecting rod and align
bores, then gently tap piston pin with a fiber
hammer to push out inner plastic ring on oppo-
site side. Support piston from opposite side.
03-05-14
F01D0SA
– As necessary, pull halves of inner sleeve with
long nose pliers.
2
F01D0TA
1. Pulling inner sleeve half
5, Circlip
Secure remaining circlip no. 5 taking into consid-
eration the following.
To minimize the stress on the circlips, install
them so that their openings are located at 6
o'clock (at bottom). Always use new circlips.
At installation, take care not to deform them.
www.SeaDooManuals.net
1
-
CAUTION