Sea-doo SP Shop Manual page 46

1
F01D3AA
1. Magneto flywheel
11, Generating Coil
To replace generating coil:
– Heat the armature plate to 93°C (200°F) around
the screw holes to break the threadlocker
bond.
F00D08A
1. Heat the armature plate
-
CAUTION
Protect harness from flame.
– Remove screws.
– Uncrimp and unsolder BLACK/RED wire from
coil.
Sub-Section 04 (MAGNETO SYSTEM)
A25E0QA
1. Uncrimp and unsolder wire here
13, Battery Charging Coil
To replace battery charging coil:
– Heat the armature plate to 93°C (200°F) around
the screw holes to break the threadlocker
bond.
1
F00D09A
1. Heat the armature plate
Protect harness from flame.
– Remove screws.
– Uncrimp and unsolder YELLOW and YEL-
LOW/BLACK wires from coil.
www.SeaDooManuals.net
Section 03 ENGINE
1
-
CAUTION
1
03-04-7