Sea-doo SP Shop Manual page 216

1
F01J1HA
1. Stamped end this side
-
CAUTION
Never hammer the bearing into its housing.
1
F00J0BA
1. Press on tool until it stops
-
CAUTION
This tool have been designed to properly po-
sition bearings and seal, thus providing
space for lubrication purposes. The tool
flanges allow this. If a different pusher type
is being used, components must be properly
positioned as follows.
Section 08 PROPULSION SYSTEM
Bearing on impeller side must be 1.5 to 2.5 mm
(.060 – .100 in) inside reservoir measured from
seal seat. Bearing on venturi side must be 2 to
3 mm (.080 – .120 in) inside reservoir measured
from thrust washer seat. Refer to following illus-
tration.
F01J1JA
1. Seal seat
2. Stamped end of bearing
3. Thrust washer seat
4. Stamped end of bearing
A. 1.5 – 2.5 mm (.060 – .100 in)
B. 2 – 3 mm (.080 – .120 in)
Seal must be installed so that lips raised edges
are toward outside of housing (toward impeller).
Apply Loctite 518 (P/N 293 800 038) to seal hous-
ing, all around outer diameter and on seal seat.
Properly insert seal on tool.
NOTE: It is important when installing seals to
pack seal lip with grease before inserting bear-
ing/seal installer tool. Properly insert tool in seal
with a rotating movement.
www.SeaDooManuals.net
Sub-Section 02 (JET PUMP)
A
1
2
B
3
4
08-02-13