Sea-doo SP Shop Manual page 167

Meter (+) lead Meter (-)
Red Red
(ring terminal) (female terminal)
Red Red/Purple
(ring terminal) (female terminal)
Red Black
(ring terminal) (ring terminal)
Black
Black/Red
(ring terminal)
Black
White/Grey
(ring terminal)
Black
Tan/Black
(ring terminal)
Yellow/Red Black
(female terminal) (ring terminal)
Yellow/Red Black
(male terminal) (ring terminal)
Black Red
(ring terminal) (ring terminal)
Most of circuit can be tested with an ohmmeter
but a 100% test doesn't mean the MPEM is in
perfect condition.
-
CAUTION
Whenever connecting MPEM, always have
battery disconnected from circuit. If MPEM
must be connected when circuit is activated,
always connect BLACK/RED wire first to igni-
tion coil/CDI module to prevent wire from
touching solenoid positive terminal.
717 Engines
Generating Coil Verification
STATIC TEST
Disconnect magneto wiring harness connector.
Install the four-pin magneto harness adapter (P/N
295 000 131).
Section 07 ELECTRICAL SYSTEM
Value
< 1Ω
< 1Ω
> 20 kΩ
F01B28A
TYPICAL
> 10 kΩ
Check resistance with a high-sensitivity ohmme-
ter. Refer to the following table for values and
> 100 kΩ
wire colors.
> 200 kΩ
PART NAME
> 10 kΩ
Generating coil
> 50 kΩ
> 10 kΩ
F01H5WA
1. Multimeter
2. Four-pin magneto harness adapter
3. RED/BLUE wire
4. BLACK wire
DYNAMIC TEST
1. Connect spark plug cables to grounding device.
2. Disconnect magneto wiring harness connector.
3. Install the four-pin magneto harness adapter (P/N
295 000 131).
4. Connect probe "N" of Bombardier Ignition
Tester to RED/BLUE wire of four-pin magneto
harness adapter.
5. Connect probe "P" of Bombardier Ignition
Tester to BLACK wire of four-pin magneto har-
ness adapter.
www.SeaDooManuals.net
Sub-Section 02 (IGNITION SYSTEM)
ADAPTER
WIRE
Black with
RED/BLUE
1
RESISTANCE
40-76 Ω
2
4 3
07-02-13