Sea-doo SP Shop Manual page 341

Section 13 WIRING DIAGRAMS
Sub-Section 01 (WIRING DIAGRAMS)
Contact Removal
Insert a screwdriver blade between the housing
and wedge lock on the lock tab side.
Pry the wedge lock to unlock the tab (open posi-
tion).
1
F00H0OA
1. Screwdriver between wedge lock and housing
2. Locking tab
Repeat the same steps for the other locking tab
retaining the wedge lock.
The wedge lock is now in the open position.
1
F00H0PA
1. Wedge lock opened
While rotating the wire back and forth over a half
turn (1/4 turn in each direction), gently pull the
wire until the contact is removed.
13-01-2
2
1. Rotate wire back and forth
2. Pull wire
Contact Installation
Make sure the wedge lock is in the open position.
To insert a contact, push it straight into the appro-
priate circuit cavity as far as it will go.
1. Wedge lock open
2. Push the wire
Pull back on the contact wire to be sure the reten-
tion fingers in the housing are holding the contact
properly.
After all required contacts have been inserted, the
wedge lock must be closed to its locked position.
www.SeaDooManuals.net
1
2
F00H0QA
-
CAUTION
The wedge lock should never be removed
from the housing for insertion or removal of
the contacts.
1
F00H0PB
2 2