Sea-doo SP Shop Manual page 235

Section 08 PROPULSION SYSTEM
Sub-Section 03 (DRIVE SYSTEM)
All Models
5,6, Floating Ring and O-ring
Position the O-ring no. 6 of the drive shaft in the
flange of the floating ring no. 5.
1
F01I0DA
1. O-ring
2. Floating ring
Position the floating ring no. 5 between the car-
bon ring no. 10 and the PTO flywheel (seal carrier
for the HX and XP models).
F02I03A
TYPICAL
1. Floating ring
08-03-12
2
1
All Models Except the XP and HX
3, Drive Shaft
Install drive shaft.
-
Take care not to break the O-ring in the float-
ing ring flange while inserting the drive
shaft.
Engage drive shaft splines in PTO flywheel. Ro-
tate shaft to properly index splines. Make sure
boot is well positioned over shaft end.
XP and HX Models Only
4, Rear Drive Shaft
Install rear drive shaft.
-
Take care not to break the O-ring in the float-
ing ring flange while inserting the drive
shaft.
Engage drive shaft splines in coupler no. 20. Ro-
tate shaft to properly index splines.
All Models
Push the floating ring to compress the boot. Insert
the O-ring in the drive shaft groove.
F02I04A
TYPICAL
1
Step : Push floating ring
2
Step : Insert O-ring in the groove
Slide the floating ring onto the O-ring.
www.SeaDooManuals.net
CAUTION
CAUTION
1 2