Sea-doo SP Shop Manual page 188

Slide stop collar no. 7 over circlip no. 6 and se-
cure in place by punching it at 2 or 3 places.
1
2
A03E0EA
1. Armature shaft
2. Circlip
3. Pinion stop collar
4. Punch
1,10, Yoke Assembly and Clutch
Housing
Align previously traced indexing marks.
F01H0QA
TYPICAL
1. Align marks
Open brushes no. 4 and slide over commutator.
Align end frame locating notch with yoke locating
protrusion and properly sit brush holder no. 2 into
yoke no. 1.
4
3
1
www.SeaDooManuals.net
Section 07 ELECTRICAL SYSTEM
Sub-Section 04 (STARTING SYSTEM)
F01H0SA
1. Locating protrusion is the higher one
F01H0TA
1. Brush holder locating notch
To ease end frame installation, retain brush holder
with a small screwdriver while installing end
frame.
1
1
07-04-7