Sea-doo SP Shop Manual page 201

Section 07 ELECTRICAL SYSTEM
Sub-Section 06 (DIGITALLY ENCODED SECURITY SYSTEM)
Basic Self-Diagnostic Mode
It is self-activated when the safety lanyard is being installed on the watercraft switch. It gives immediate
monitoring. Some codes may occur only when pressing the start/stop button. Refer to the following
chart.
SIGNAL
2 short beeps
(while installing
safety lanyard on
watercraft switch)
1 long beep
(while installing
safety lanyard on
watercraft switch or
when pressing
start/stop button in
some cases)
8 short beeps
Continuous beep
07-06-2
CAUSE
• Safety lanyard is
recognized by the MPEM.
• Bad connection between
safety lanyard cap and
switch.
• Unprogrammed or
defective safety lanyard.
• Salt water in safety
lanyard cap.
• Improper operation of
MPEM or defective wiring
harness.
• Defective MPEM
(memory).
• Engine overheating.
• Ignition is authorized, engine can start.
• Remove and replace the safety lanyard on the
switch until 2 short beeps are heard to indicate
the system is ready to allow engine starting.
• Use the safety lanyard that has been programmed
for the watercraft. If it does not work, check
safety lanyard condition with the programmer.
Replace safety lanyard if reported defective. If it
still does not work, enable more detail about the
failure.
• Clean safety lanyard cap to remove salt water.
• Enable advanced diagnostic mode to obtain more
detail about the failure.
• Replace MPEM.
• Refer to TROUBLESHOOTING 02-01.
www.SeaDooManuals.net
REMEDY