Sea-doo SP Shop Manual page 234

1
F05I08A
1. Alignment tool
2. Seal carrier
Torque seal carrier nuts no. 19 to 7 N•m (62 lbf•in)
in a criss-cross sequence as per following illustra-
tion.
NOTE: It is very important to tighten nuts of seal
carrier in a criss-cross sequence to maintain its
alignment.
1
3
5
F05I0EA
16,17, Damper and Bushing
Make sure to install dampers no. 16 and bushings
no. 17 on front drive shaft no. 8.
Section 08 PROPULSION SYSTEM
2
F05I0FA
ENGINE SIDE SHOWN
1. Damper
2. Bushing
7,20, Front Drive Shaft and Coupler
Install front drive shaft no. 7 and coupler no. 20.
4,15, Rear Drive Shaft and Damper
Install damper no. 15 on rear drive shaft.
6
All Models Except the XP and HX
15, Damper
Install damper no. 15 on drive shaft no. 3.
NOTE: Make sure dampers were not left in PTO
flywheel or impeller.
4
2
www.SeaDooManuals.net
Sub-Section 03 (DRIVE SYSTEM)
1 2
08-03-11