Sea-doo SP Shop Manual page 217

Section 08 PROPULSION SYSTEM
Sub-Section 02 (JET PUMP)
1
F01J1KA
1. Raised edge of seal this side
-
CAUTION
Prevent sealant from contacting any needles
of bearing.
Push on tool end with a press until tool flange con-
tacts housing.
1
F00J0CA
1. Press on tool until it stops
Apply synthetic grease (P/N 293 550 010) be-
tween seal lips.
08-02-14
2
F01J1MA
1. Loctite 518 all around and behind
2. Raised edge of seal lip this side
25, Thrust Washer
Position jet pump housing no. 9 with the stator
vanes on top.
Insert thrust washer no. 25 in the stator seat.
1
F00J0DA
1. Thrust washer properly installed in stator seat
26, Thrust Bearing
Apply Sea-Doo jet pump synthetic oil (P/N 293
600 011) on both sides of thrust bearing.
Position thrust bearing no. 26 on thrust washer
no. 25.
www.SeaDooManuals.net
1