Sea-doo SP Shop Manual page 219

Section 08 PROPULSION SYSTEM
Sub-Section 02 (JET PUMP)
1
F00J0HA
1. Impeller shaft holder secured in a vice
To ease impeller installation, apply BOMBARDIER
LUBE lubricant on wear ring.
Insert impeller into wear ring. Manually rotate im-
peller and push so that it slides on impeller shaft
threads. Carefully engage threads making sure
they are well aligned.
Install impeller remover/installer tool into impeller
splines and tighten.
F00J08A
1. Impeller remover/installer tool
-
CAUTION
Make sure thrust washer and bearing are
not wedged in shaft groove. To check, man-
ually pull and push impeller housing, some
axial play must be felt (maximum 0.54 mm
(.021 in)).
08-02-16
1
Torque impeller to 70 N•m (52 lbf•ft) then remove
tools.
-
Never use any impact wrench to tighten im-
peller.
Apply synthetic grease (P/N 293 550 010) on im-
peller splines.
Insert a new boot no. 15 and ring no. 16 to impel-
ler.
F00J0IA
1. Boot and ring
18, Cover
Install O-ring no. 27 to cover. Apply Loctite 518 on
O-ring. Install cover to impeller housing making
sure to properly position filler plug on top side.
F01J5IA
1. Filler plug toward top side of pump housing
www.SeaDooManuals.net
CAUTION
1
1