Sea-doo SP Shop Manual page 301

Section 11 HULL/BODY
Sub-Section 02 (ADJUSTMENT AND REPAIR)
F05D04A
GS, GSI, GSX, GTI, GTX, XP and HX Models
Remove nuts, lock washers and flat washers re-
taining jet pump support.
F07L0AA
TYPICAL — GTX MODEL SHOWN
1. Remove nuts
Using a heat gun, heat jet pump support until it is
possible to pull it.
11-02-20
1
www.SeaDooManuals.net
NOTE: Shims may have been installed between
support and body. Do not remove these shims,
otherwise jet pump alignment will be altered.
Installation
Apply Loctite 598 Ultra Black as indicated by the
shaded areas in the next illustrations. Follow also
the torquing sequence as shown in the same illus-
trations.
3
1
F07L0CA
GS, GSI, GSX, GTI AND GTX MODELS
F05J0EA
HX MODEL
4
2