Sea-doo SP Shop Manual page 175

787 Engine
Stator
STATIC TEST: CONTINUITY
1. Disconnect the magneto wiring harness con-
nector.
2. Install the six-pin magneto harness adapter
(P/N 295 000 136).
3. Check resistance between two of the YELLOW
wires. The resistance should be between 0.1 to
1.0 ohm.
F01H5ZA
1. Multimeter
2. Magneto harness adapter
3. YELLOW wires
4. Place either meter lead into the remaining YEL-
LOW wire and note the resistance (same as
step no. 3). If the readings are out of specifica-
tion, the stator will need to be replaced.
STATIC TEST: INSULATION
1. Disconnect the magneto wiring harness con-
nector.
2. Install the six-pin magneto harness adapter
(P/N 295 000 136).
3. Insert multimeter + lead to one of the YELLOW
wire of the six-pin magneto harness adapter.
4. Ground the multimeter – lead to the engine or
the stator iron core and note the reading.
3 1
3 2
www.SeaDooManuals.net
Section 07 ELECTRICAL SYSTEM
Sub-Section 03 (CHARGING SYSTEM)
4
F01H60A
1. Multimeter
2. Magneto harness adapter
3. + lead to YELLOW wire
4. – lead to ground
5. Repeat test with the other two YELLOW wires
of the six-pin magneto harness adapter.
NOTE: There should be no continuity (infinity) be-
tween the stator insulated coils and ground. If
there is a reading, the stator coils and/or the wir-
ing from the coils is grounded and needs to be
replaced or repaired.
3
1
2
07-03-3