Using The Reset Config Button - Juniper J-series Services Router J2350 Hardware Manual

JUNOS Software with Enhanced Services Hardware Guide
CAUTION: Use extreme caution when disabling J-series power management. To
prevent equipment damage, do not install a combination of PIMs that exceeds the
power or heat capacity of your router when J-series power management is disabled.
To reenable J-series power management, remove the
disable-power-management
about the
see the JUNOS System Basics Configuration Guide.
Resetting the Configuration File When the Router Is Inaccessible
You can use the router's
file when the current one is faulty or fails. You can also change the default behavior
of the

Using the RESET CONFIG Button

If a configuration fails or denies management access to the router, you can use the
RESET CONFIG
rescue configuration. For example, if someone inadvertently commits a configuration
that denies management access to a router, you can delete the invalid configuration
and replace it with a rescue configuration by pressing the
button is recessed to prevent it from being pressed accidentally.
160
Resetting the Configuration File When the Router Is Inaccessible
Remove one or more PIMs from the chassis. This option requires that you
power off the router. For more information about removing PIMs, see
"Removing a PIM" on page 120
Bring the PIM online without powering off the router. To do so, use the
chassis fpc offline command to set another PIM slot in the chassis to the
offline state. For example:
user@host# set chassis fpc 2 offline
If the power and heat tokens no longer exceed the maximum, the PIMs that
were placed offline by J-series power management are brought online
automatically.
Use the
set chassis disable-power-management
power management:
user@host# set chassis disable-power-management
The
set chassis disable-power-management
online automatically.
command from the configuration. For detailed information
set chassis fpc offline and
RESET CONFIG
button.
RESET CONFIG
button to restore the router to the factory default configuration or a
command to disable J-series
command brings the offline PIMs
set chassis
set chassis disable-power-management
button to restore the router's configuration
RESET CONFIG
set
commands,
button. The