Connecting To A Services Router - Juniper J-series Services Router J2350 Hardware Manual

JUNOS Software with Enhanced Services Hardware Guide

Connecting to a Services Router

You can connect to the Services Router using the J-Web or CLI interface. You can
connect to the CLI from a remote location through two dial-up modems. For details
see, "Connecting to the CLI Remotely" on page 100.
96
Connecting to a Services Router
Install the Services Router in its permanent location, as described in "Installing
and Connecting a Services Router" on page 77.
Gather the following information:
Hostname for the router on the network
Domain that the router belongs to on the network
Password for the root user
Time zone where the router is located
IP address of an NTP server (if NTP is used to set the time on the router)
IP address of a DNS server
List of domains that can be appended to hostnames for DNS resolution
IP address of the default gateway
IP address to be used for the loopback interface
IP address of the built-in Ethernet interface that you will use for management
purposes. The examples in this guide use the
If you are performing the initial configuration with the J-Web interface, collect
the following equipment:
A management device, such as a laptop, with an Ethernet port
An Ethernet cable (provided)
If you are performing the initial configuration with the CLI, collect the following
equipment:
A management device, such as a PC or laptop, with a serial port and an
asynchronous terminal application (such as Microsoft Windows
Hyperterminal)
An RJ-45 to DB-9 serial port adapter (provided)
An Ethernet cable (provided)
For a remote connection, two dial-up modems
For a remote modem connection, a DB-9 female to DB-25 male adapter, or
other adapter appropriate for your modem (not provided)
ge-0/0/0 interface.