Juniper J-series Services Router J2350 Hardware Manual page 128

JUNOS Software with Enhanced Services Hardware Guide
To configure basic settings with J-Web Quick Configuration:
1.
2.
3.
4.
NOTE: After initial configuration is complete, the Services Router stops functioning
as a DHCP server. If you change the IP address of
device configured to use DHCP, you lose your DHCP lease and your connection to
the router through the J-Web interface. To reestablish a connection, either set the IP
address on the management device manually, or connect
management network and access the router another way—for example, through the
console port.
5.
Table 42: Set Up Quick Configuration Summary
Field Function
Identification
Host Name Defines the hostname of the router.
(required)
Domain Name Defines the network or subnetwork that the
machine belongs to.
Root Password Sets the root password that user "root" can
(required) use to log in to the router.
Verify Root Password Verifies the root password has been typed
(required) correctly.
104
Configuring Basic Settings with J-Web Quick Configuration
If you have not already done so, connect a management device to the
interface on port 0/0. For instructions, see "Connecting to the J-Web
Interface" on page 97.
If the Set Up Quick Configuration page is not displayed, select
Configuration>Quick Configuration >Set Up.
Enter information into the Set Up Quick Configuration page, as described in
Table 42 on page 104.
Click one of the following buttons:
To apply the configuration and stay in the Set Up Quick Configuration page,
click Apply.
To apply the configuration and return to the Quick Configuration page, click
OK.
To cancel your entries and return to the Quick Configuration page, click
Cancel.
To check the configuration, see "Verifying Basic Connectivity and the
Configuration" on page 113.
ge-0/0/0 and have the management
ge-0/0/0
Your Action
Type the hostname.
Type the domain name.
Type a plain-text password that the system encrypts.
NOTE: After a root password has been defined, it is
required when you log in to the J-Web user interface
or the CLI.
Retype the password.
ge-0/0/0
to the