Juniper J-series Services Router J2350 Hardware Manual page 145

CAUTION: Do not hot-swap WXC Integrated Services Modules. Failure to power off
the router before removing or installing a WXC Integrated Services Module might
result in damage to the hardware.
Figure 59: Removing a PIM
To remove a PIM (see Figure 59 on page 121):
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
1.
PIM.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
2.
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the Services Router is disconnected from earth ground. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 201.
3. Press and release the power button to power off the router. Verify that the
LED blinks and then turns off.
Label the cables connected to the PIM so that you can later reconnect each cable
4.
to the correct PIM.
Disconnect the cables from the PIM.
5.
If necessary, arrange the cables to prevent them from dislodging or developing
6.
stress points:
Secure each cable so that it is not supporting its own weight as it hangs to
the floor.
Place excess cable out of the way in a neatly coiled loop.
Use fasteners to maintain the shape of cable loops.
Loosen the captive screws on each side of the PIM faceplate.
7.
Grasp the handles on each side of the PIM faceplate, and slide the PIM out of the
8.
router. Place it in the electrostatic bag or on the antistatic mat.
If you are not reinstalling a PIM into the emptied slot, install a blank PIM panel
9.
over the slot to maintain proper airflow.
Chapter 8: Replacing Hardware Components
Replacing a PIM
POWER
121