J2320 And J2350 Front Panel - Juniper J-series Services Router J2350 Hardware Manual

Normally, a J2320 or J2350 Services Router boots from the internal compact flash.
If the internal compact flash fails, the router attempts to boot from the external
compact flash if it is installed. If the external compact flash is not present or fails,
the router attempts to boot from the USB storage device.

J2320 and J2350 Front Panel

The front panel of a J2320 or J2350 Services Router (see Figure 8 on page 13 and
Figure 9 on page 13) allows you to install or remove PIMs, view router status LEDs,
access the console port, and perform simple control functions.
Figure 8: Front of J2320 Chassis
Figure 9: Front of J2350 Chassis
The components of the front panel, are described in the following sections:
USB storage device
Physical Interface Modules (PIMs) on page 14
Power Button and POWER LED on page 14
STATUS LED on page 15
ALARM LED on page 15
HA LED on page 16
RESET CONFIG Button on page 16
Built-In Gigabit Ethernet Ports on page 17
Chapter 2: J-series Services Router Hardware Features
J2320 and J2350 Services Router Hardware Features
13