Juniper J-series Services Router J2350 Hardware Manual page 155

Figure 69: Removing the J4350 or J6350 Compact Flash
Place the compact flash on the antistatic mat or in the electrostatic bag.
8.
Slide the new compact flash into the slot and press down, as shown in
9.
Figure 70 on page 131.
Figure 70: Inserting the J4350 or J6350 Compact Flash
NOTE: On some Services Routers the compact flash is in a horizontal position. If the
compact flash connection is horizontal, lay the compact flash behind the slot and
slide it forward until it clicks into place.
Slide the cover onto the chassis.
10.
Replace and tighten the screws on the sides and top of the chassis that secure
11.
the cover to the chassis.
Replacing Internal Compact Flashes on J4350 and J6350 Routers
Chapter 8: Replacing Hardware Components
131