Mazda 6 Workshop Manual page 93

Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME DATA been recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Verify related service repair information
availability.
• Is any related repair information available?
3 VERIFY CURRENT SIGNAL STATUS: IS
CONCERN INTERMITTENT OR CONSTANT?
• Connect the WDS or equivalent to the DLC-2.
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
4 INSPECT APP SENSOR CONNECTOR FOR
POOR CONNECTION
• Turn the engine switch off.
• Disconnect the APP sensor connector.
• Inspect for poor connection (such as damaged/
pulled-out pins, corrosion).
• Is there any malfunction?
5 INSPECT APP SENSOR NO.1 SIGNAL CIRCUIT
FOR SHORT TO POWER SUPPLY
• Turn the engine switch to the ON position
(Engine off).
• Measure the voltage between APP sensor
terminal B (wiring harness-side) and body
GND.
• Is the voltage more than 4.7 V?
6 INSPECT APP SENSOR NO.1
• Inspect the APP sensor No.1.
• Is there any malfunction?
7 INSPECT PCM CONNECTOR FOR POOR
CONNECTION
• Turn the engine switch off.
• Disconnect the PCM connector.
• Inspect for poor connection (such as damaged/
pulled-out pins, corrosion).
• Is there any malfunction?
8 INSPECT APP SENSOR NO.1 GND CIRCUIT
FOR OPEN CIRCUIT
• Turn the engine switch off.
• Inspect for continuity between APP sensor
terminal D (wiring harness-side) and PCM
terminal 91 (wiring harness-side).
• Is there continuity?
9 VERIFY TROUBLESHOOTING OF DTC P0123
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
10 VERIFY AFTER REPAIR PROCEDURE
• Perform the Repair Verification Drive Mode.
(See F2–39 OBD DRIVE
• Are any DTCs present?
End Of Sie
ON-BOARD DIAGNOSTIC
INSPECTION
MODE.)
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order,
then go to the next step.
Yes Perform repair or diagnosis according to the available
repair information.
• If the vehicle is not repaired, go to the next step.
No Go to the next step.
Yes Go to the next step.
No Intermittent concern exists.
Perform the "INTERMITTENT CONCERNS
TROUBLESHOOTING".
Yes Repair or replace the terminal, then go to Step 9.
No Go to the next step.
Yes Repair or replace the wiring harness for a possible short to
power supply, then go to Step 9.
No Go to the next step.
Yes Replace the APP sensor, then go to Step 9.
No Go to the next step.
Yes Repair or replace the terminal, then go to Step 9.
No Go to the next step.
Yes Go to the next step.
No Repair or replace the wiring harness for a possible open
circuit, then go to the next step.
Yes Replace the PCM, then go to the next step.
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See F2–40 DTC TABLE.)
No DTC troubleshooting completed.
ACTION
F2–81
F2