Dtc P0336 - Mazda 6 Workshop Manual

STEP
13 VERIFY TROUBLESHOOTING OF MISFIRE DTC
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
14 VERIFY AFTER REPAIR PROCEDURE
• Perform the Repair Verification Drive Mode.
(See F2–39 OBD DRIVE
• Are any DTCs present?
End Of Sie

DTC P0336

DTC P0336 CKP sensor range/performance problem
• The PCM monitors the input signal from the CKP sensor while the engine is running. If the input signal from
the CKP sensor does not correspond with the proper pulse number, the PCM determines CKP sensor
performance problem.
DETECTION
Diagnostic support note
CONDITION
• The MIL does not illuminates.
• The DTC is stored in the PCM memory.
• CKP sensor malfunction
• Connector or terminal malfunction
POSSIBLE
• CKP sensor pulsar malfunction
CAUSE
• PCM malfunction
F2–116
ON-BOARD DIAGNOSTIC
INSPECTION
MODE.)
Yes Replace the PCM, then go to the next step.
No Go to the next step.
Yes Go to the applicable DTC troubleshooting.
(See F2–40 DTC TABLE.)
No Troubleshooting completed.
ACTION
B6E407000300102