Dtc P0341 - Mazda 6 Workshop Manual

STEP
12 VERIFY AFTER REPAIR PROCEDURE
• Perform the Repair Verification Drive Mode.
(See F2–39 OBD DRIVE
• Are any DTCs present?
End Of Sie

DTC P0341

DTC P0341 CMP sensor range/performance problem
• The PCM monitors the input signal from the CMP sensor while the engine is running. If the input signal
from the CMP sensor does not correspond with the proper pulse number, the PCM determines CMP
sensor performance problem.
DETECTION
Diagnostic support note
CONDITION
• The MIL does not illuminates.
• The DTC is stored in the PCM memory.
• CMP sensor malfunction
• Connector or terminal malfunction
POSSIBLE
• CMP sensor pulsar malfunction
CAUSE
• PCM malfunction
F2–120
ON-BOARD DIAGNOSTIC
INSPECTION
MODE.)
Yes Go to the applicable DTC inspection.
(See F2–40 DTC TABLE)
No Troubleshooting completed.
ACTION
B6E407000300104