Programming The Control; Change Installer Code - Honeywell LYNX Touch Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide

Programming the Control

After entering the System Programming mode select from the options provided on the First and Second
Installer Programming screens as shown in the accompanying figure.
System Programming...
Installer Code
Date Time
Comm. Diagonostics
Zones
Keys
Page 1

Change Installer Code

The factory default Installer Code for the LYNX Touch Control is set to 4-1-1-2.
SCREEN
Installer Code
5000-100-129-V0
System Type
Communicator
Save
Reporter
5000-100-013-V0
1. Select "Installer Code".
2. Enter a new four-digit Installer Code on the displayed keypad The system will display the
new code on the left side of the screen.
3. Select "Done" when you are finished.
4. The system returns to the "System Programming" Screen.
WWW.DIYALARMFORUM.COM
System Programming...
Sounder
Default Config.
ACTION
- 20 -
System Settings
5000-100-035-V0
Page 2