Honeywell LYNX Touch Series Installation And Setup Manual page 49

Secondary User Codes
In normal operation mode, the Master Security Code can be used to assign up to 14 secondary 4-digit
security codes, including a Babysitter Code and a Duress Code. The Master Code can also be used to remove
secondary codes from the system (individually). Refer to the LYNX Touch User Manual for additional
information.
•
The Master and Secondary security codes permit access to the system for arming, disarming, etc.
•
The Installer Code can disarm the system only if it was used to arm it. In addition, the Installer Code cannot
disarm the system if it was armed by pressing and holding a Quick-Arm button.
•
The Babysitter Code can disarm the system only if it was used to arm it. In addition, the Babysitter Code cannot
disarm the system if it was armed by pressing and holding a Quick-Arm button.
•
Duress code sends a special code to the monitoring station when used to perform any system operation. Instruct
users to be careful not to use this code for normal usage.
•
Opening/closing reports are sent for the Installer Code, with the appropriate subscriber number. Master Code and
set of secondary user codes are sent as Nos. 02 and 03–14, respectively, in Contact ID® format (with the
appropriate user number).
WWW.DIYALARMFORUM.COM
LYNX Touch Installation and Setup Guide
Security Code Notes
- 49 -
System Operation