Honeywell LYNX Touch Series Installation And Setup Manual page 25

SCREEN
Supervision
24 Hours
Old Alarm Time
10 Minutes
Remote Acc. IP or GSM
Disabled
Multi Mode IP or GSM
Disabled
IP Fault Time (min)
00
Use DHCP
Yes
NIC IP Address
255.255.255.255
Subnet Mask
255.255.255.255
Gateway IP Address
255.255.255.255
DNS Server IP Address
255.255.255.255
GSM Fault Time (min)
00
WWW.DIYALARMFORUM.COM
6. Select "Supervision". The system scrolls between the following options:
24 Hours
None
30 Days
7. Select "Old Alarm Time". The system scrolls between the following options:
10 Minutes 15 Minutes
30 Minutes 1 Hour
2 Hours 4 Hours
8 Hours 12 Hours
Use the down arrow to scroll to the next page of options.
24 Hours
8. Select "Remote Acc. IP or GSM". The system toggles between "Disabled" and
"Enabled".
9. If "Remote Access IP or GSM" was enabled in the previous step, the "Multi Mode IP
or GSM" option is displayed. The system scrolls between the following options.
Disabled
Relay Reports
Enhanced Reports
10. Use the down arrow to scroll to the next page of options. If IP or IP & GSM was
selected in step 2, proceed to step 11. If GSM was selected in step 2, proceed to
step 19.
11. Select "IP Fault Time (min)". Enter the time delay (in minutes) on the displayed
keypad.
Options
00-99
13. Select "Use DHCP". The system toggles between "Yes" and "No". If "No" is selected
the system displays four additional options. If "Yes" is selected, skip to step 18.
14. Select "NIC IP Address". Enter the 4-part address on the displayed keypad.
15. Select "Subnet Mask". Enter the 4-part address on the displayed keypad.
16. Select "Gateway IP Address". Enter the 4-part address on the displayed keypad.
17. Select "DNS Server IP Address". Enter the 4-part address on the displayed keypad.
18. If "IP" was selected in step 2, select "Save" and then select "OK" when the
"Programming Done" screen appears. Proceed to "Diagnostics" section in order to
register the device.
19. Select "GSM Fault Time (min)". Enter the time delay (in minutes) on the displayed
keypad.
Options
00-99
20. If "GSM" was selected in step 2, select "Save" and then select "OK" when the
"Programming Done" screen appears. Proceed to "Diagnostics" section in order to
register the device.
- 25 -
LYNX Touch Installation and Setup Guide
Programming the Control
ACTION