Program Zones - Honeywell LYNX Touch Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide
Programming the Control

Program Zones

The following system options are programmed in this section:
Option
Serial Number
Loop Number
Zone Description 1/2
Device Type
Response Type
Alarm Report
Chime
Supervision
Note: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unless otherwise noted.
SCREEN
Zones
5000-100-133-V0
Serial Number
Loop Number
1
Zone Description 1
Manually enter device serial number or enroll via RF transmission
Manually enter device loop number or enroll via RF transmission
Enter Zone Descriptors for the device being enrolled
Select the type of device being enrolled
Select the alarm response for the device being enrolled (refer to Zone Response Type Table)
Activate reporting option for the device being enrolled
Enable/disable chime mode for specific device being enrolled (applies to Entry/ Exit, Perimeter,
and Interior Response types only)
Select supervision for device being enrolled
1. Select "Zones"
The System displays the following options:
1. New
3. Back Door
5. Motion Sensor
2. Use the down arrow to scroll to the next page of options. Use the
the previous page.
7. – 48. New
49. – 56. 4 Button
57. – 64. New
95. Fire
96. Medical
99. Police
3. Select a zone and then select "Edit" or "Add New" to program the next available zone. The
following options are displayed (dependant upon Zone Type):
Serial Number
Zone Description 1
Device Type
Alarm Report
4. Select an option to display the next programming field.
Serial Number
When "Serial Number" has been selected "Enter Serial Number or Activate" is displayed. The
transmitter serial number and loop number can be enrolled via RF transmission OR manually.
Enroll via RF Learning To enroll the device using RF Learning mode three transmissions
(open/close) of the device will be required. The initial transmission activates the RF Learning
mode and the system will emit a single beep. A second transmission enrolls the serial number
and the system beeps two times and displays "Activate Sensor Again To Confirm". A third
transmission will confirm the serial number. The system beeps two times and returns to the
Zone programming Screen.
Enroll Manually
Enter the 7-digit serial number printed on the transmitter using the displayed keypad and
select "Done". The system beeps one time and returns to the Zone programming Screen.
Loop Number
Select "Loop Number" to toggle between 1, 2, 3 and 4. Enter Save.
Zone Description 1
Select "Zone Description 1". Using the displayed keypad enter Zone Description 1. The
system announces the Zone Description. Enter "Done", when you are finished. The system
returns to the Zone Programming page.
Zone Description 2
Select "Zone Description 2". Using the displayed keypad enter Zone Description 2. The
system announces the Zone Description. Enter "Done", when you are finished. The system
returns to the Zone Programming page.
WWW.DIYALARMFORUM.COM
Function
ACTION
2. Front Door
4.Window
6.New
Loop Number
Zone Description 2
Response Type
Chime Supervision
- 26 -
arrow to return to