Honeywell LYNX Touch Series Installation And Setup Manual page 32

LYNX Touch Installation and Setup Guide
Programming the Control
SCREEN
Phone Type
None
Communicator Type
None
Phone Number
Account Number
FFFF
Dynamic Priority
Redundant Reports
Dynamic Delay
30 Seconds
Report All
Press to Report All
Report Alarms
Disabled
Report Troubles
Disabled
Report Open/Close
Disabled
Report Tests
Disabled
Phone 1
Phone Type
None
Phone Number
Report All
Press to Report All
Report Alarms
Disabled
Report Troubles
Disabled
Select "Phone Type". The System displays the following options:
None
Contact Id: 4 Digit
Contact Id: 10 Digit
SIA
Select "Communicator Type". The System displays the following options:
None
GSM or IP
Note: The system will display the communications path (GSM or IP) selected in Communications
Programming. The path can be enabled for either primary Central Station or Secondary Central
Station but not both. If it is enabled in one it will not be available for the other Central Station.
If any option other than "None" is selected in "Phone Type", the "Phone Number" option will
be displayed. Select "Phone Number". Enter the Secondary Central Station Phone Number
on the displayed keypad.
If any option other than "None" is selected in "Phone Type" The "Account Number" option will
be displayed. Select "Account Number". Enter the Secondary Central Station Account
Number on the displayed keypad.
If any option other than "None" is selected in "Communicator Type" The "Dynamic Priority"
option will be displayed. "Select "Dynamic Priority". The system scrolls between "Redundant
Reports", "Preferred Telco" and Preferred Radio".
If any option other than "Redundant Reports" is selected in "Dynamic Priority" The "Dynamic
Delay" option will be displayed. "Select "Dynamic Delay". The system scrolls between "15
Seconds", "30 Seconds", "60 Seconds" and "90 Seconds".
Note: If GSM is selected as the primary reporting channel Dynamic Delay should be set to
minimum of 60 seconds.
Select "Report All". The System toggles between "Press to Report All" and "Report All Set". If
"Report All" is selected all reporting options will be "Enabled". Select the "Save" key to return
to the Reporter options screen.
Select "Report Alarms". The System toggles between "Disabled" and "Enabled".
Select "Report Troubles". The System toggles between "Disabled" and "Enabled".
Select "Open/Close". The System toggles between "Disabled" and "Enabled".
Select "Report Tests". The System toggles between "Disabled" and "Enabled".
Select "Phone 1" to program the "Follow Me" Reminder telephone number 1
Select "Phone Type". The System toggles between "None" and "Follow Me".
Select "Phone Number". Enter the "Follow Me" Phone Number 1 on the displayed keypad.
Select "Report All". The System toggles between "Press to Report All" and "Report All Set". If
"Report All" is selected all reporting options will be "Enabled". Select the "Save" key to return
to the Reporter options screen.
Select "Report Alarms". The System toggles between "Disabled" and "Enabled".
Select "Report Troubles". The System toggles between "Disabled" and "Enabled".
WWW.DIYALARMFORUM.COM
ACTION
- 32 -