Function Button; Drag Label; Load Presets - junger d07 Operation Manual

Digital transmission processor

Hide thumbs Also See for d07:

Table of Contents

The virtual signal flow is divided into processing sections represented

by a set of parameter windows and a 3D function button with a label

on it. The label will change its colour from grey to yellow if the value of

one of the processing parameter is in a range where this processing

section becomes active. Pressing such a function button will set the relevant parameters to a value

leading that processing section to become momentarily inactive – bypass function for that section.

The DRAG LABEL is a GUI tool to adjust the related parameter. The parameter value is displayed

numerically and by a bar within the label. For doing changes of parameters you must bring the mouse

cursor over the label. Holding down the left mouse button and moving the mouse horizontally will

change the value in fine steps but slowly. Holding down the right mouse button will

change the value in big steps but fast. Clicking on the right mouse button when the

mouse arrow is close to the horizontal edges of a drag label will make it jump to the

respective boundaries of the values.

While "on air" you can load a preset from the

From here you can select one of the USERx

device.

4.6.1 FUNCTION BUTTONS

devices memory.

or one of the FACTORY presets

OPERATION

stored within the

page 4-7

Table of Contents

Chapters

Table of Contents