junger d07 Operation Manual page 71

NETWORK INTEGRATION
of Jünger Audio devices
C8000-modules via C8702 LAN Controller
To operate the Junger audio devices via web browser you have get an Ethernet
connection DEVICE < - > PC. If you are not familiar with the network setup, please
consult a network administrator for assistance and read ALL the manual carefully!
There are two ways to communicate with the device via ethernet:
1.
You can connect the device to the LAN your PC is integrated (if there is one
existing already)
2.
You can connect the device directly to your PC using an Ethernet crossover
cable.
In both cases network settings of the device or your PC or even both have to
be changed and matched.
The default network configuration of the Jünger devices is:
IP Address: on a label at the Ethernet connector socket at the rear of the
device
Netmask: 255.255.0.0.
Gateway: 10.110.0.1.
Integration into existing LAN
1.
When you want to integrate the device into an existing LAN you have to change its
IP-address, the (sub)network mask and the gateway. You will get valid settings
from your network administrator.
You can do that two ways:
A
Connecting the device over a serial cable to your PC and change the
network configuration with a terminal program (e.g. HyperTerminal
included in Windows installation)
B
Disconnect your PC from your LAN (physically), match your PC's network
setup to the setup of the device for getting access to the device via
Ethernet crossover cable, change the device's network configuration via
Ethernet crossover cable. Then change again your PC's configuration and
connect both your PC and the device to the LAN.
d07
d06
Level Magic LT
B 6 – Network Integration
6
B