junger d07 Operation Manual page 73

You will get to the Hyper terminal window:
Press ENTER and you will get the following information of the device:
Now you can change the network configuration so that it fits into your LAN.
You might have changed the IP-address of the device, so please renew the label at
the rear of the device, otherwise it will cause confusion.
When you ever initialize the device the default IP-address and network
configuration will be active again. In case of need you can read the default IP-
address always on the controller in the device!
B)
You can also change the IP address of the device over Ethernet connection.
Disconnect your PC from the LAN, connect it to the device directly via Ethernet
crossover cable (not connected 1 to 1, but 1 to 8 etc...). Change the network
configuration of your PC (write down the current settings, you need them later to
reconnect to your LAN!) via "Local Area Connection Properties" (Windows: Start ->
Settings -> Network connections -> Local Area Connections)
B 6 – Network Integration