Data Transfer - junger d07 Operation Manual

System configuration
Change network configuration:
IP-address, netmask, gateway
Only possible when your network configuration is adjusted to the
preconfiguration of the device, see "NETWORK INTEGRATION"
Back up / restore
Using the backup function a whole d07-data set (setup and parameters) can be saved
as a html-file into a folder of your choice. You can use this file to restore all the
parameters of your device at a later date or to load this data set into another device.
Software update
To update the software of the web interface controller you just have to load the
update-image and press "update". The image does also contain contingent updates
for the controller of the device. This update will be automatically offered when you go
to the "GLOBAL" page of the d07 module.
Reboot controller
Rebooting the device activates the changes you have made to the network
configuration. If you have changed the IP address of the device, you are not able to
reach the web interface after the reboot. You have to use the new address, of course!

4.2.3. DATA transfer

All changes you make at the web browser interface are
immediately transmitted to the device.
If you make any changes at the front panel of the d07 you
have to refresh the web browser page to get the data
transferred. Only a preset load is reported directly to the web
interface. The change of a preset name is only transmitted by
refresh.
Web browser
A 4.2 – operation via web browser
immediately transmitted
and executed
immediately executed
d07
transmitted by refreshing the
web site
d07
Web browser