Serial Remote Control - junger d07 Operation Manual

The d07 can be remote-controlled by means of serial remote RS-232/422 or
via the CAN-bus.
use : remote-controlled changeover of presets
protocol: available on request
Connector : D-SUB 9pin, female
Pin assignment of the connector in serial interface mode :
Pin Signal name
1 Rx +
2 TxD
3 RxD
4 NC
5 GND
6 Rx -
7 NC
8 Tx -
9 Tx +
Pin assignment in CAN-bus mode :
Pin Signal name
1 NC
2 CAN-l
3 NC
4 NC
5 GND
6 GND
7 CAN-H
8 NC
9 NC
This connector has multiple functions which may be internally changed by
connectors and jumpers. The factory default format setting is RS232 and the it
is connected with the serial interface of the LAN Controller.
By using a terminal program (115kB/sec. 8,N,1 no flow control) you may
communicate with the consol of the LAN Controller, e.g. to change the IP
configuration of the device.
Functions
RS422
RS232
RS232
not used
Ground
RS422
not used
RS422
RS422
Functions
Not used
CAN-bus low signal
Not used
Not used
Ground
Ground
CAN-bus high signal
Not used
Not used
2.8.3
SERIAL REMOTE
CONTROL
(RS-422)
A 2 –Installation