Table of Contents
Advertisement
Operation
The d07 transmission processor is very easy to use.
You can do all settings with the keys on the front of the device, via
remote or software.
The d07 uses two groups of data, in the CONFIG area to set up
device functions (selection of an input, synchronization or input of a
device name) and in the PARAMETER area to control the signal
processing (setting up processing parameters, MPX-limiter, etc.).
directs to the set up menus. Here one can select between
SETUP
CONFIG for device related settings and PARAMETER for signal
processing settings.
directs to loading, saving and editing of one of the user
PRESET
PRESETs.
All current data is kept in a non volatile memory. Therefore they are
immediately available when turning on the device. All changes to a
parameter are effective immediately. Pressing
By pressing
the changes will be rejected and the display
ESC
returns to the parameter menu.
Loading of a PRESET will immediately carry over the values into the
operating memory. By clicking free cross fade they will be effective
immediately.
There is the possibility to edit and store PRESETs in the back ground,
without taking them over into the operating memory to prepare the
device for a different kind of program that is awaited.
NAVIGATION through menus of the d07 is done by the
ENTER
- directs into the next possible navigation level
ENTER
- exit settings
- stores altered values
- directs back to the previous navigation level
- abort (changes are rejected)
ESC
- back to the previous navigation level
- scrolling through the navigation level
and
- switching status like ON or OFF
- altering of values
keys :
ESC
ENTER
will approve it.
4
A
4.1
FRONT PANEL
OPERATION
Function of the
d07 keys
4.1.1.
NAVIGATION
A 4.1. – Front Panel Operation
Advertisement
Chapters
Table of Contents
